TEST START
#1. Which type of fit is obtained if the hole is bigger than the shaft?
#2. What is the least count of Vernier height gauge?
#3. What is the disadvantage of mass production?
#4. What is the point angle of drill for drilling mild steel?
#5. What is the formula for finding maximum limit size in BIS system?
#6. What is an advantage of mass production?
#7. How many fundamental deviations are in BIS system?
#8. Which part of drill forms the cutting edge?
#9. What is the maximum limit size of dimension Dia. 25 (+0.003, -0.001)?
#10. What is the definition of ‘tolerance’ in BIS system?
Finish
Results
-
congratulation
you have passed the test
try again you can pass the test
